Difficulty: 2/5
Time: 1hr
Tools:
- screw driver
- allen wrenches
- zip ties
EJK Instruction:
1 Remove side panels
2. Disconnect negative battery terminal
3. Locate fuel injector and unplug it
4. Plug matching EJK connector on to the injector.
5. Plug male EJK connector into the Factory female connector.
6. Attach EJK black ground wire to negative battery or to the frame
7. Mount EJK in safe location, I did it using velcro tape under my seat.
Settings: electronicjetkit.com
Make sure you START YOUR BIKE to check functionality of the controller. DO NOT JUST TURN THE KEY ON. You will see the Red and Green flashing lights with just the key on. This is normal since power is being supplied to the injector, but no signal is being generated.
No comments:
Post a Comment